Refractory Design & Engineering
Lining selection based on your service temperature, atmosphere and mechanical duty. GA drawings, lining detail, BOQ and install schedule provided with every offer.
What we do
A lining partner, not just a supplier.
Every lining we sell can be specified, detailed, installed and commissioned by our team.
Installation Supervision
Our engineers supervise on-site masonry, casting and dry-out. We verify joint thickness, anchor placement, curing and heat-up schedule against the design.
Turnkey Execution
Full-scope lining contracts — demolition, supply, installation, dry-out and handover — with a single point of responsibility.
Anti-Corrosive Linings
Acid-proof brick & tile linings, membrane systems and chemical-resistant floors for reactor vessels, tanks and pickling bays.
Thermal Insulation
Hot-face and cold-face insulation system design, ceramic-fibre modular linings and calcium-silicate backup for energy-efficient operation.
Repair & Maintenance
Scheduled shutdown repairs, patch casting, hot repairs, spray-gunning and emergency response for production-critical linings.
Troubleshooting & Audits
Lining failure analysis, wear mapping, refractory audit and specification review — to extend campaign life and cut unplanned downtime.
How we work
Four steps, clearly scoped.
01
Discovery
We capture service temperature, atmosphere, cycle, geometry and failure history.
02
Design
Grade selection, lining detail and BOQ are issued with a priced offer.
03
Install
Supply, masonry or casting, and dry-out are executed under engineer supervision.
04
Support
Post-commissioning inspection, performance review and campaign-life tracking.